Wax Moth - A Pest of Combs and Honey Bee Products
Note Number: AG1101
Published: April 2003
Updated: April 2009
This Agriculture Note provides information for apiarists about wax moth, a damaging pest of beeswax combs, comb honey and bee-collected pollen.
Introduction to wax moth
Wax moth larvae are very destructive and can quickly destroy stored beeswax combs. They tunnel and chew through combs, particularly combs that have contained brood and pollen.
Healthy, populous honey bee colonies do not tolerate wax moth larvae in the hive. Wax moths are never the initial cause of colony destruction but in weak colonies their larvae can damage combs not covered and protected by bees.
Greater wax moth (Galleria mellonella)
Adult moths are pale brown to grey, usually about 20 mm long. The grey wings are often mottled and appear as "roof" or "boat" shaped when folded over the body.
Female moths usually lay 300 to 600 eggs in clusters on comb or in small cracks in hive material. The almost spherical, pinkish to white eggs are about 0.5 mm in diameter.
The eggs hatch within 3 - 5 days when temperatures range from 29C to 35C. Hatching is delayed when temperatures are colder and at 18C hatching commences about 30 days after egg laying.
Larvae are creamy white, but turn grey on reaching their fully grown size of up to 28 mm in length. After hatching, the small very active larvae tunnel in comb, lining their tunnels with silky web as they go. They move from comb to comb through a mass of webbing.
Newly hatched larvae may move to neighbouring honey bee colonies. Overseas laboratory studies have shown that newly hatched larvae can travel more than 50 metres.
Wax moth larvae are very active in warm weather, but become inactive in the extreme cold of winter. At the optimum temperature of about 32C they reach full development about 19 days after hatching. At cooler temperatures, and when food is scarce, the larval period may extend to 5 months.
Fully developed larvae spin silky cocoons that may be found in a mass of webbing in the comb, and on the frames and internal surfaces of the hive. Larvae may form small canoe shaped depressions in the wooden hive components in which to spin their cocoons. Larvae can also bore through the wooden bars of frames.
After spinning the cocoon, the larvae commence the pupal stage which lasts about 14 days when temperatures are high but as long as 2 months during cooler temperatures.
After emergence, adult moths mate and the life-cycle begins again.
Lesser wax moth (Achroia grisella)
This moth is smaller than the greater wax moth and has a silver-grey to dull-yellow, slender body about 13 mm in length.
Lesser wax moth larvae are usually white with a brown head. They feed on combs, pollen and litter found on the hive floor. They are usually solitary, whereas greater wax moth larvae often congregate in large numbers.
Damage caused by wax moths
Honey bee colonies that have become weak and have low numbers of adult bees resulting from starvation, queenlessness, excessive swarming, disease, pesticide poisoning or neglect cannot effectively guard their hive against wax moth infestation. At first, combs left unattended by bees are attacked. As the colony weakens further, even combs with bees may be damaged.
On occasions, one or two wax moth larvae may be seen in a healthy, populous hive. These are mostly removed by adult bees and very little, if any, damage occurs. Sometimes, one or two wax moth larva occur between the hive mat and the top bar of a frame. Again, these individuals cause little, if any, damage and may be removed by the beekeeper.
Bald brood and deformed honey bee pupae
Developing honeybee pupae are exposed when wax moth larvae partly remove the cell caps, a condition known as bald brood. Worker bees chew the remainder of the capping thereby fully exposing the heads of the pupae which continue to develop normally. The lines of bald brood follow the direction of the wax moth's travel.
Some honey bee pupae nearing maturity may have deformed legs or wings. One of the causes of this deformity is a result of wax moth excreta affecting the final moult of the pupa before its emergence from the cell.
Newly formed adult bees are sometimes unable to emerge from their cells. These bees are trapped by silken threads produced by greater wax moth larvae tunnelling at the base of the cells. The bees eventually die and are later removed by hive bees. This is a minor problem and is rarely seen.
Damage to stored combs and hive material
Damage will vary with the level of infestation and the time that has elapsed since the infestation first began. In time, stored combs may be completely destroyed and the frames and combs become filled with a mass of tough, silky web. In ideal conditions for wax moth development, a box (super) of combs may be rendered useless in about a week.
Damage occurs mainly in the warm and hot months of the year when wax moths are most active. However, considerable damage can still occur during the cool part of late autumn and early spring as greater wax moth can produce a large amount of metabolic heat which can raise the immediate temperature around them by up to 25C above the normal environment temperature. Little if any damage is seen in the extremely cold winter period, because the larvae are relatively inactive.
At the time of storage, combs that are apparently free of wax moth may contain eggs that will hatch later. They should be monitored at frequent intervals for signs of moth infestation unless treated (as discussed later).
Adult moths may also lay eggs in the external cracks and joints of stacked supers of combs. After hatching, the tiny larvae quickly tunnel though the joints to infest the combs. This explains why some combs that have been treated by freezing to kill all life-cycle stages of the moth, are later found infested.
Wax moth larvae prefer dark brood combs that contain some pollen. However, combs sticky with honey after extracting, white combs and combs containing honey are still at risk of attack.
Larvae may damage frames and hives by chewing the wood to make cavities for cocoons.
Damage to apiary products
Wax moth larvae grow extremely well on a diet of fresh or dried pollen. Adult wax moths may deposit their eggs whenever pollen is exposed while in the pollen trap on the hive, and during processing and packaging. The eggs can hatch at any time, even after packaging, making the pollen unsuitable for human consumption.
Honey sold in the comb should be protected immediately it is taken from the hive. Wax moth eggs present on the comb at the time of packaging will hatch soon after and the webbing and excreta produced by the larvae will render the comb unfit for sale.
Clean, refined beeswax including foundation is not readily subject to wax moth attack. Damage is usually minor and the larvae usually fail to grow to full size. Dirty, unrefined beeswax and slum gum is more readily infested.
Control of wax moth
The control measures described below are effective for both the greater and lesser wax moth.
Slum gum, old combs and scraps of beeswax are best collected and processed to form clean cakes of beeswax. If left unprocessed, these items can provide an ideal environment for development of wax moth.
Combs and other items infested with wax moth are best treated or destroyed. A clean environment will always assist in minimising the incidence of wax moth.
Hives with bees
Maintain strong, populous colonies and wax moth invasion will be curtailed. Weak colonies may be united with other colonies of bees to form one strong colony.
Some beekeepers who store combs in late autumn and reuse them in early spring find that control methods are not needed because the winter temperatures prevent or minimise any wax moth activity. The success of this method depends on the winter temperature in the district. Careful monitoring of stored combs on a regular basis, even during winter, is essential.
Some beekeepers may temporarily store a super of empty combs above the mat and beneath the cover of the hive occupied by a strong honey bee colony. The bees protect the combs from wax moth.
During good honey producing seasons, combs of honey removed from hives for extracting may be left for a short period of time before they are again used on a hive. Beekeepers find that if this period of rotation is short, there is little opportunity for wax moth infestation to occur.
All life-cycle stages of the wax moth, including eggs, are killed by freezing at the following temperatures and times:
- - 6.7C at 4.5 hours
- -12.2C at 3 hours
- -15.0C at 2 hours.
It is important to commence timing of this treatment only when the hive material or apiary products have reached the recommended temperature. A number of hobby beekeepers have purchased small freezers and find freezing an excellent means of protecting their combs.
After freezing, the combs should be stored in a moth-proof environment to prevent re-infestation. Sealed, strong plastic garbage bags provide a good insect-proof storage environment.
Combs that have been frozen and then placed in untreated supers for storage are immediately at risk to infestation because the supers may contain wax moth eggs. It is best to treat the super and combs and then place them together in a sealed plastic bag.
The use of cool rooms to store combs and protect them from wax moths has become increasingly popular in the beekeeping industry. A temperature of 4C will restrict wax moth activity.
Bee collected pollen
Collecting pollen from pollen traps every 2 or 3 days will help to minimise, but not prevent wax moth infestation. Drying and packaging of bee-collected pollen should be done in a moth-proof environment and the product frozen to kill all life-cycle stages of the moth. Allow sufficient time for the product to cool to the desired temperature before timing the commencement of the treatment. Freezing of pollen after packaging will ensure that the product is free of wax moth eggs and will not be at risk of infestation until the package is opened.
This product may also be frozen to control all life-cycle stages of wax moth. However, some types of honey (for example, clover and lucerne) may candy after freezing. Allow time for the product to cool to the desired temperature before timing the commencement of the treatment. To some extent, freezing comb honey for 24 - 48 hours can eliminate the guesswork.
Comb honey may also be held in cool rooms but this treatment will not kill wax moth eggs.
This Agricultural Note was developed by Russell Goodman in April 2003.
It was reviewed by:
Russell Goodman in May 2006.
Russell Goodman in May 2008.
Russell Goodman, April 2009.
Published and Authorised by:
Department of Environment and Primary Industries
1 Spring Street
This publication is copyright. No part may be reproduced by any process except in accordance with the provisions of the Copyright Act 1968.
The advice provided in this publication is intended as a source of information only. Always read the label before using any of the products mentioned. The State of Victoria and its employees do not guarantee that the publication is without flaw of any kind or is wholly appropriate for your particular purposes and therefore disclaims all liability for any error, loss or other consequence which may arise from you relying on any information in this publication